Beer Can Chicken Rub Recipes

BEER CAN CHICKEN

Steps:

• Preheat an outdoor grill for medium-high heat, about 375 degrees F (190 degrees C). Mix the brown sugar, chili powder, paprika, dry mustard, salt, and ground black pepper in a small bowl. Place the half-full can of beer in the center of a plate.
• Rinse chicken under cold running water. Discard giblets and neck from chicken; drain and pat dry. Fit whole chicken over the can of beer with the legs on the bottom; keep upright. Sprinkle 1 teaspoon of the seasoning mix into the top cavity of the chicken. The beer may foam up when the seasonings fall inside the can. Rub the remaining seasoning mix over the entire surface of the chicken.
• Place the chicken, standing on the can, directly on the preheated grill. Close the lid and barbeque the chicken until no longer pink at the bone and the juices run clear, about 1 hour 15 minutes. An instant-read thermometer inserted into the thickest part of the thigh, near the bone should read 180 degrees F (82 degrees C). Remove the chicken from the grill and discard the beer can. Cover the chicken with a doubled sheet of aluminum foil, and allow to rest in a warm area for 10 minutes before slicing.

TEXAS DRY RUB BEER CAN CHICKEN

Steps:

• In a small bowl combine the rub ingredients.
• Remove and discard the neck, giblets, and any excess fat from the chicken. Rinse the chicken, inside and out, under cold water and pat dry with paper towels. Lightly spray or brush all over with the vegetable oil and season, inside and out, with the rub. Let rest at room temperature while you preheat your grill.
• Open the beer can an pour off half of the beer. (Or drink it if you don't want to waste it.) Set the half-full can of beer in can holder (or if you don't have a can holder, just be extra careful and place the can on a flat smooth surface), and add fresh rosemary leaves, minced shallot and lemon juice. This will help add moisture and flavor from the inside as your chicken cooks. You may need to use a funnel, to help add the ingredients to the can.
• Slide the chicken over the top so the can fits inside the cavity. Transfer the bird to your preheated grill, while carefully keeping the can upright. Carefully balance the bird on its two legs and the can holder. (If can holder is not used just use the can and use the legs like a tripod.) Grill over Indirect Medium heat until the juices run clear and the internal temperature reaches 170 F in the breast and 180 F in the thickest part of the thigh. 1 - 1/4 to 1 - 1/2 hours. Wearing barbecue mitts, carefully remove the chicken and the can (holder) from the grill. Do not spill the beer, it will be HOT. Let the chicken rest for about 10 minutes before lifting it from the can (holder). Discard the beer. Cut the chicken into serving pieces. Serve warm.
• ENJOY!

BEER CAN CHICKEN WITH MEMPHIS RUB

Steps:

• Remove and discard the fat just inside the body cavities of the chicken. Remove the package of giblets, and set aside for another use. Rinse the chicken, inside and out, under cold running water, then drain and blot dry, inside and out, with paper towels.
• Sprinkle 1 tablespoon of the rub inside the body and neck cavities, then rub another 1 tablespoon all over the skin of the bird. If you wish, rub another 1/2 tablespoon of the mixture between the flesh and the skin. Cover and refrigerate the chicken while you preheat the grill.
• Set up the grill for indirect grilling (see instructions below) placing a drip pan in the center. If using a charcoal grill, preheat it to medium.
• If using a gas grill, place all the wood chips in the smoker box and preheat the grill to high; then, when smoke appears, lower the heat to medium.
• Pop the tab on the beer can. Using a "church key" style can opener, make 6 or 7 holes in the top of the can. Pour out the top inch of beer, then spoon the remaining dry rub through the holes into the beer. Holding the chicken upright, with the opening of the body cavity down, insert the beer can into the cavity. (Caution: the beer fizzes when you add the rub!).
• When ready to cook, if using charcoal, toss half the wood chips on the coals. Oil the grill grate. Stand the chicken up in the center of the hot grate, over the drip pan. Spread out the legs to form a sort of tripod, to support the bird.
• Cover the grill and cook the chicken until fall-off-the-bone tender, 2 hours. If using charcoal, add 10 to 12 fresh coals per side and the remaining wood chips after 1 hour.
• Using tongs, lift the bird to a cutting board or platter, holding the metal spatula underneath the beer can for support. (Have the board or platter right next to the bird to make the move shorter. Be careful not to spill hot beer on yourself.) Let stand for 5 minutes before carving the meat off the upright carcass. (Toss the beer can out along with the carcass.).
• Memphis Rub:.
• Combine all the ingredients in a jar, twist the lid on airtight, and shake to mix. Store away from heat or light for up to six months. Makes about 1/2 cup. Enough for 4 to 6 racks of ribs.
• ** Indirect grilling on a Charcoal Grill:.
• To set up you grill for indirect grilling, light the coals. When they are blazing red, use tongs to transfer them to opposite sides of the grill, arranging them in two piles. Some grills have special half-moon-shaped baskets to hold the coals at the sides; others have wire fences that hook onto the bottom gate. Let the coals burn until they are covered with a thin layer of gray ash. Set the drip pan in the center of the grill, between the mounds of coals. Place the food on the grate over the drip pan, and cover the grill. You'll need to add about 10 to 12 fresh briquettes to each side after an hour of cooking.
• If you want to add a smoke flavor, add 1 to 2 cups of presoaked wood chips, or 2 to 4 chunks, to the coals just before you start to cook, and again whenever you replenish the coals.

PAT'S BEER CAN GRILLED CHICKEN

Steps:

• For the chicken rub: In a small bowl mix all the ingredients together and use for the grilled chicken. You can store extra rub mixture in an airtight container for up to 6 months.
• For the chicken: Preheat your grill to medium-high heat.
• Rub the chicken and its cavity down with the vegetable oil. Season the chicken with rub mixture, remembering to season the cavity. Pour out 1/4 of the beer and sit the chicken on top of the beer can. Place the chicken in the center of the hot grill and cover. Cook the chicken for 1 to 1 1/2 hours, or until an instant-read thermometer registers 165 degrees F. Once cooked, cover loosely with foil and let rest for 10 minutes before carving.

SPICE RUBBED BEER CAN CHICKEN

Steps:

• Heat a gas or charcoal grill with a lid big enough to accommodate the bird. Put a drip pan below the grates.
• Mix the ingredients for the Spice Rub until they are well blended. (This will keep, covered, in the refrigerator for 1 week.) Rub it all over the chicken, inside and out.
• Open the beer and take a big swig or just pour out a couple of ounces. Sit the chicken on the beer can so the legs are at the bottom and the wings are at the top. Stand the beer can on the grates over the drip pan. Put the cover on and cook over indirect heat until the juices run clear, about 1 hour. (If using charcoal, push the coals to 1 side so the chicken is not over direct heat.)
• Note: This chicken can also be cooked in a 350 degrees F oven. Just stand the beer can in a shallow roasting pan and cook about 1 hour or until juices run clear.

BEER-CAN CHICKEN

Steps:

• Pour out (or drink) half of beer.
• Prepare grill for high, indirect heat and fit with grill pan (for a charcoal grill, bank coals on 1 side of grill and put drip pan on empty side; for a gas grill, leave 1 burner turned off and place drip pan over unlit burner). Add water to pan to a depth of 1/2".
• Season chicken with 4-3-2-1 Spice Rub. Place cavity of chicken, legs pointing down, onto open can so that it supports chicken upright. Place can, with chicken, on grill over indirect heat (and above drip pan). Grill chicken, covered, until cooked through and an instant-read thermometer inserted into the thickest part of thigh registers 165°F, 45-60 minutes. (If using charcoal, you may need to add more to maintain heat.) Let chicken rest 10 minutes before carving. Serve with pan drippings.

BEER CAN CHICKEN

Steps:

• In a small bowl, combine the first 6 ingredients. Gently loosen skin from the chicken. Brush chicken with oil. Sprinkle 1 teaspoon spice mixture into cavity. Rub the remaining spice mixture over and under the skin. Place lemon slices in neck cavity. Tuck wing tips behind the back., Prepare grill for indirect heat, using a drip pan. Pour out half the beer, reserving for another use. Poke additional holes in top of the can with a can opener. Holding the chicken with legs pointed down, lower chicken over the can so it fills the body cavity., Place chicken over drip pan; grill, covered, over indirect medium heat until a thermometer reads 180° 1-1/4 to 1-1/2 hours. Remove chicken from grill; cover and let stand for 10 minutes. Remove chicken from can.

BEER CAN CHICKEN

Steps:

• Light a lidded barbecue. Let the flames die down and the coals turn ashen, then mound the coal up on one side. If using a small barbecue, you will have to remove the grills and place a sturdy roasting tin on the floor of the barbecue, next to the coals - this will give you space to close the lid once the chicken is in. If you have a large barbecue, the chicken can sit directly on the grills (or on a tray on the grills, so that it doesn't topple over.)
• To make the rub, mix all the ingredients together with a good grinding of black pepper. Drizzle the chicken with the oil, sprinkle over the rub and massage it into the skin, making sure you get into all the nooks and crannies, even inside the cavity.
• Use a can opener to take off the top of the can of beer. Pour out half the beer (tip into a glass to drink!) and leave the rest in the can, as it will keep the chicken moist while it cooks. Pop the chicken onto the can, legs down, so that it looks like it is sitting upright with the can in its cavity. Stand the chicken and can upright on the barbecue, either in the roasting tin or directly on the grill, on the side with no coals. Close the lid and cook for 1 hr 20 mins until the chicken is browned, the meat tender and the juices run clear. If the juices aren't clear, cook for a further 10 mins, then check again. (To cook in the oven, heat to 200C/180C fan/gas 6. Sit the chicken on a baking tray, place in the bottom of the oven, and follow the same cooking time.)
• Remove the chicken from the barbecue, cover lightly with foil and leave to rest for 20 mins before serving.