Beef Back Ribs On The Pellet Grill Recipes

BEEF BACK RIBS ON THE PELLET GRILL

Steps:

• Remove the beef ribs from the vacuum packaging and discard it in the trash.
• Don't rinse the meat in the sink. Pat dry with paper towels.
• Remove the membrane using a butter knife to lift and a spoon to further lift the membrane until you reach the other side. Then use your paper towel to grip and rip the membrane away from the bones.
• Using your rub of choice, apply a liberal amount to the meat. I personally used Highland Farms Maple Pepper but a good beef rub is equal parts kosher salt and pepper.
• Allow the marinade to dry brine over night in the refrigerator.

PELLET-GRILL SMOKED RIBS

Steps:

• Preheat a pellet grill to 275 degrees F (see Cook's Note). Combine 2 tablespoons salt, 4 tablespoons coarsely ground pepper and 2 teaspoons paprika in a small bowl. Rub each rack of ribs all over with 1 tablespoon oil and sprinkle evenly with the salt and spice mixture on both sides.
• Transfer the ribs, meat-side up, to the grill grates. Cover the grill and cook for 1 hour.
• Meanwhile, combine 1/3 cup cider vinegar with 1/3 cup water in a spray bottle. After 1 hour spray the ribs with the vinegar-water mixture so they are damp all over. Cover and cook for 1 more hour.
• Meanwhile, combine the ketchup, 3/4 cup water, the remaining 1/3 cup cider vinegar, white vinegar, brown sugar, Worcestershire sauce, 2 teaspoons salt, 2 teaspoons pepper, hot sauce and the remaining 2 teaspoons paprika in a medium saucepan. Cook over medium heat until the mixture is warmed through and the sugar is melted, about 2 minutes. Set aside.
• Check the ribs and spray them again with vinegar-water. They should be starting to take on a red color from the smoke. Cover and cook until they are deep red, 30 to 45 minutes. Spray the ribs once more, then brush the meaty part of each rack with 1/4 cup of the sauce. Close the grill and cook for another 15 minutes so the sauce can set.
• Lay down two pieces of heavy-duty foil that are long enough to enclose each rack on a work surface and spread half of each sheet with 1/4 cup sauce. Transfer the rib racks, meat side down, onto the saucy part of the foil. Coat the bone sides with 1/4 cup sauce and a few sprays of the vinegar-water, then fold the foil over and seal tightly.
• Add another layer of foil if the first has punctured during wrapping. Transfer the ribs to a rimmed baking sheet and place on the grill (the baking sheet will catch any juices that leak out). Cover and cook until tender but not falling off the bone, about 2 hours.
• Remove from the grill and let rest 5 minutes before carefully unwrapping (watch out for hot steam). Slice each rack into individual rib portions and serve with the remaining sauce.

SMOKED BEEF BACK RIBS RECIPE - TRAEGER GRILLS

Steps:

• If your butcher has not already done so, remove the thin, papery membrane from the bone-side of the ribs by working the tip of a butter knife underneath the membrane over a middle bone. Use paper towels to get a firm grip, then tear the membrane off.
• Season both sides of ribs with Traeger Beef Rub.
• When ready to cook, set the Traeger temperature to 225°F and preheat with the lid closed for 15 minutes.
• Insert the probe horizontally into the center of the meaty section of the ribs, avoiding the bones. Set the ribs directly on the grill grates, bone-side down. Close the lid and cook until the internal temperature reaches 205℉, 8-10 hours.
• Remove ribs from grill and let rest, lightly covered with foil, for 20 minutes before slicing and serving. Enjoy!