Crispy Beer Battered Halibut Recipes

CRISPY BATTERED HALIBUT WITH NO BEER

Steps:

• Prep your fish by removing the skin (if any) and cutting into pieces sized about as big as a deck of cards prior to mixing your batter.
• Preheat your oil as well. Ideal frying temperature is about 365. If the oil is not hot enough you'll end up with greasy fish. If it's too hot you'll burn the batter before the fish is cooked through. The batter needs to be used immediately after it's mixed. Baking powder is temperamental and doesn't wait for cold oil!
• Combine all the dry ingredients except for the bread crumbs, and stir well to evenly distribute. Stir in the cold water and immediately dip fish in the batter, and then do a quick coat in the bread crumbs and carefully put into the preheated oil.
• Cook until golden brown and the fish is cooked through.

BEER BATTER HALIBUT

Steps:

• Divide halibut fillet into approximately 1.5" cubes.
• Mix dry ingredients, add beaten egg. Pour beer in until proper consistency. Batter will be smooth and a little runny but thicker than water.
• The remaining beer is yours to enjoy.
• Add oil to frying pan until oil is approximately 1/2 the height of the halibut cubes; heat on medium high until suitable for deep frying.
• Make a test piece:.
• Coat halibut piece in batter, add to oil. Fry for two minutes, then turn with tongs (being very careful of oil spattering) and fry another two minutes. Transfer finished piece to a paper towel covered plate. Split piece with fork to check for doneness, if piece does not split easily and/or middle of halibut piece does not appear to be opaque, adjust cooking time and/or oil temperature to ensure pieces are done.
• When satisfied with cooking time, repeat until all pieces have been cooked (multiple pieces can be put in pan).
• Serve warm with tartar sauce.

BEER-BATTERED HALIBUT WITH TARTAR SAUCE

Steps:

• For the tartar sauce: In a bowl, add the parsley, tarragon, shallot, and cornichon. Chop the hard boiled egg by removing the yolk and crumbling it, then dice the white. Add both yolk and whites to the bowl. Add vinegar, salt, mustard, mayonnaise, and a few dashes of hot sauce (or more to taste). Stir to combine and set aside.
• For the beer batter: In a large mixing bowl, mix the cake flour and baking soda with a fork. Slowly pour in the beer, stirring the entire time (it's okay if there are a few lumps). The batter should be thin, falling off the fork easily so it coats the fish, not heavy like pancake batter. Set aside.
• Fry the halibut: Fill a deep heavy-bottomed pan with oil-don't go higher than 2 inches from the rim-and heat to 350 degrees F. Season the halibut with salt on both sides. Test the oil by cooking a few drops of batter; they should float to the surface when the oil's hot enough. Remove these "tester crunchies" with a slotted spoon. One piece at a time, drop the fish into the beer batter, then remove it, letting the excess drip off. Then place it halfway into the oil, letting a crust form for 10 seconds, then releasing it gently into the pan. Repeat with two more pieces (three at a time), so the pan isn't overcrowded and cook each for 3-4 minutes. Remove the fish to a baking sheet fitted with a wire rack to drain any excess oil. Season with flaky sea salt and serve with tartar sauce and lemon wedges.

CRISPY BEER BATTERED HALIBUT

Steps:

• Slice fish into rectangular fillets, roughly 6 inches by 2 inches. Remove skin if needed and pat dry with paper towels.
• Prepare your batter by adding 1/2 cup whole wheat flour, Old Bay, and egg to a shallow bowl. Stir a couple of times to break the yolk. Add beer and use a whisk or fork to combine until smooth. Set aside.
• Add vegetable oil to a large pot or saucepan, so that the oil is about 3 inches deep. Turn your heat source up to medium and monitor the temperature of the oil with a kitchen thermometer. Your target is to get your oil to 375°F.
• In a second shallow bowl, add 1/4 cup of whole wheat flour.
• Working with one fish fillet at a time, dip your fish into the flour first, coating completely. Then, take your flour-coated fish and dunk it into your beer batter, making sure you have an even layer of batter coating your fish.
• Carefully drop your battered fish into the hot oil, frying for 4 minutes total. Use a skimmer or sieve to flip the fish after 2 minutes, to ensure an even cook. Repeat with all of your fish fillets, making sure to not overcrowd your oil-the battered fish will stick together if they get too close.
• Carefully remove your fried fish from the oil and place it on a paper towel to absorb excess oil.
• Serve immediately with lemon wedges.

BEER BATTERED HALIBUT

Steps:

• Pat halibut filets dry and dredge in extra flour. Mix together flour, cornstarch, baking powder and dash of each salt and pepper. Add enough of the beer to make a pancake-like batter. ( Not too runny but thick enough to coat fish). Do not over stir as batter will become tough.
• Coat fish in batter and let extra drip off back into bowl.
• Oil should be preheated at 365.
• Place carefully in hot oil and cook for 8 - 10 minutes until golden in colour and fish is cooked.

CRISPY BEER-BATTERED FISH

Steps:

• In a shallow bowl, combine the cornstarch, baking powder, salt, Creole seasoning, paprika, cayenne and 1/2 cup flour. Stir in milk and beer until smooth. Place crackers and remaining flour in separate shallow bowls. Coat fillets with flour, then dip in batter and coat with crackers., In an electric skillet or deep-fat fryer, heat oil to 375°. Fry fish in batches for 2-3 minutes on each side or until golden brown. Drain on paper towels.

LIGHT AND CRISPY FRIED HALIBUT

Steps:

• Heat oil in a deep-fryer or large saucepan to 350 degrees F (175 degrees C).
• Whisk eggs, milk, and flour together in a shallow bowl. Stir panko bread crumbs and seasoned bread crumbs together in another bowl.
• Gently dip halibut squares into egg mixture, the press gently into bread crumbs mixture to generously coat completely. Place breaded halibut in a single layer on a plate while breading the rest.
• Cook halibut in preheated oil until golden brown and crisp on the outside, 4 to 6 minutes.

BEER-BATTERED FISH AND CHIPS

Steps:

• Preheat the oven to 250 degrees F.
• For the chips: Fill a 6- to 8-quart Dutch oven with oil to a depth of about 5 inches. Heat to 365 degrees F on a deep-fry thermometer.
• Cut the potatoes in half lengthwise, then cut each half into thirds lengthwise, making wide strips. Place the potatoes in a medium saucepan with enough cold water to cover by about 1 inch. Salt the water generously and bring to a boil over high heat. Reduce the heat and simmer for about 5 minutes. Drain the potatoes and transfer them to a sheet pan lined with paper towels to dry for about 10 minutes. Once the potatoes are very dry, working in 2 batches, gently transfer them to the oil and fry until golden brown and crispy, 3 to 6 minutes.
• Transfer the chips to a rack set over a baking sheet and sprinkle immediately with 1 to 2 teaspoons salt. Keep warm in the oven while you fry the fish. (You can also reheat them with a quick second fry while fish is cooling slightly.)
• For the fish: Place the fillets on a small baking sheet or large plate, blot dry with paper towels and sprinkle on all sides with 1 teaspoon salt and 1/2 teaspoon pepper. Move the fish to one side and place 1/2 cup of flour on the other side (this flour is for dusting the fish just before dipping it in batter). Season the flour with a pinch of salt and a few grinds of pepper.
• To make the batter, place the remaining 1 cup flour, garlic powder, paprika, baking powder, a pinch of salt and a few grinds of pepper in a medium bowl. Stir together with a fork until combined. When ready to fry, pour in the beer and whisk until smooth. The batter should be the consistency of fairly thin pancake batter.
• Dredge the fish on all sides in the flour on the baking sheet. Shake off any excess. Working in 2 batches, coat one fillet at time in the batter, letting excess drip back into the bowl. Gently lower the fillet into the hot oil. Repeat with the remaining fillets. Fry until GBD (golden brown and delicious), 4 to 6 minutes, turning over midway through cooking.
• Drain the fillets on a rack set over a sheet pan. Serve immediately with the chips. Classic condiments to serve alongside include malt vinegar, tartar sauce or HP Sauce.

CRISPY BEER BATTER FISH & CHIPS

Steps:

• Whisk self-rising flour, rice flour, and baking powder together in a bowl. Freeze until ready to use.
• Pat fish as dry as possible. Cut pieces lengthwise to get eight 1-inch thick strips. Place rice flour on a plate and season with salt. Dust fish lightly with the mixture and shake off excess. Cover a plate with crinkled foil to make a quick drying rack; place fish on top.
• Heat oil in a deep-fryer to 375 degrees F (190 degrees C).
• Pour beer into the flour mixture and whisk, adding more as needed, until batter is the consistency of thick pancake batter. Dip fish pieces into the batter to coat; lift out and let excess drip off.
• Fry fish in batches until golden brown, dunking occasionally if needed, 3 to 4 minutes. Drain on paper towels. Serve immediately.