Easter Bonnets Alcoholic Beverage Recipes

EASTER BONNETS (ALCOHOLIC BEVERAGE)

Steps:

• Place first 4 ingredients in a tall glass.
• Add ice to top of glass and fill with champagne.
• Garnish with a slice of orange, a cherry or slice of pineapple.
• Serve with a straw.

EASTER BONNET, PART TWO

Steps:

• To assemble: Use a pastry brush to coat the bottom half of each petal with a little Simple Syrup or warmed corn syrup. This will act as the "glue" to adhere the petals to the bud. Wrap the first petal around the base of the bud. Continue adding petals in the same fashion until you have formed the size of flower you would like. Gently squeeze the bottom of the bud so the petals open. You can also gently roll back the tops of the petals to achieve a more realistic appearance. Cut off the bottom of the bud. Place around the brim of the hat and add the leaves as desired.
• To make the ganache: If using gelatin sheets, place them in a medium-size mixing bowl with enough cold water (about 2 cups) to cover. Let stand for about 5 minutes to allow the gelatin to soften and hydrate. Cold water hydrates the gelatin without letting it absorb too much liquid. Remove the gelatin from the bowl and squeeze out the excess water with your hands. If you use powdered gelatin, sprinkle the gelatin over 1/4 cup (1.75 ounces; 50 grams) of cold water. Let the gelatin bloom until it has absorbed all the water, about 1 minute. Place the chopped chocolate in a medium-size mixing bowl. Pour the heavy cream in a 1-quart heavy-bottomed saucepan over medium-high heat until bubbles begin to form around the edge of the pan. Remove from the heat and make a ganache by pouring the hot cream over the chocolate. Let stand for about 30 seconds to allow the heat to distribute throughout the bowl. Add the hydrated gelatin and gently stir the mixture with a rubber spatula. The hot cream will cause the chocolate and the gelatin to melt. Slowly mixing the heavy cream and chocolate together causes the fats in them to combine to form an emulsion. Stir the ganache until it is smooth and homogenous. Place the mixing bowl in the ice bath and stir the ganache occasionally so it cools evenly. The ganache is ready when it has thickened. Test this by using a rubber spatula to draw a line through it. If the line holds for 10 to 15 seconds, it is ready. If the line fills in immediately, the ganache is too warm. Keep cooling and retest every 30 seconds. The ganache should not cool so much that it begins to harden and set. If this happens, warm it up over a saucepan of simmering water, removing it every 10 seconds and whisking it gently until it is smooth and viscous.
• To finish the mousse: While the ganache is cooling, pour the heavy cream into another medium-size mixing bowl and beat to soft peaks with an electric mixer on medium speed. Be careful; if you overwhip the heavy cream, it will lose volume and the mousse will not be as light and airy. When the ganache is cool but not cold, fold in the whipped cream in 2 additions until combined. The ganache should not be so cold that it has begun to set and is grainy, yet is should be cool enough that it doesn't melt the whipped cream. If the mousse begins to seize while you are folding in the whipped cream, warm it up over a saucepan of simmering water 5 seconds at a time until it is smooth again. Do not warm it so much that the whipped cream begins to melt. Then fold in any remaining whipped cream. When all of the whipped cream has been incorporated, the mousse will be loose and pourable. Don't worry; it will set up in the freezer.
• Prepare the pound cake: Cut the pound cake into a 4-inch flat circle and a 5 1/2-inch flat circle. You want the larger circle to be just a bit smaller than the diameter of your mold. That way, the mousse will cover the edge and the cake won't show through the mold. Place the mousse into a pastry bag with a large opening (no tip). Pipe the mousse into the dome mold, filling about two thirds full. Spread the mousse up the sides of the mold with the back of a large spoon. Place the smaller cake circle in the mousse. Soak the cake with the simple syrup. Fill with more mousse until almost full. Top with the larger cake circle and press down slightly. Soak the cake with the simple syrup. Place the mold in the freezer for at least 1 hour to allow the mousse to set. At this stage, the cake will hold in the freezer for up to 1 week. Spread a 1/8-inch thick layer of tempered white chocolate onto a piece of parchment paper. Let the chocolate harden until firm but not set, about 5 minutes. To make the brim of the hat, trace around a 10-inch cardboard cake circle or serving plate to cut a circle from the white chocolate. Place a clean sheet of parchment paper over the chocolate sheet and flip over both. Peel off the parchment paper. Separate the chocolate cutout and place on a cardboard cake circle.
• To assemble: Unmold by dipping the mold in hot water for 5 seconds. Press against one side of the mousse to slide it out of the dome mold. Place the dome, cake side down, in the center of the white chocolate circle. Prepare the paint sprayer: Place equal amounts of white chocolate and cocoa butter over a double boiler and melt until smooth with no lumps. Assemble the dessert and place in the freezer for about 10 minutes. The surface of the dessert must be chilled so the chocolate coating will harden upon contact, giving it the desired texture. Remove the dessert from the freezer and place on a platter or cake circle. Place the chocolate mixture in a clean paint sprayer and use it to spray the dessert with the chocolate. Cleanup will be much easier if you use a plastic-lined cardboard box as a backdrop to the dessert when you spray it.
• Add the decorations. Let thaw in the refrigerator for about 1 hour before serving. The Bonnet will hold in the refrigerator for up to 24 hours.
• Yield: 6 to 8 servings
• Sources:
• Team Torres LLC
• www.mrchocolate.com
• PO Box 303
• New York, NY 10101-0303
• 212/489-4847
• 212/489-0142 (fax)
• 6-inch Dome Mold
• Beryl¿s Cake Decorating & Pastry Supplies
• www.beryls.com
• PO Box 1584
• North Springfield, VA 22151
• 800/488-2749
• 703/750-3779 (fax)
• Modeling chocolate in white or dark, assorted cutters, cocoa butter, powdered and paste food colorings, white and dark chocolate
• Sur La Table
• Catalog Division
• www.surlatable.com
• 800/243-0852
• Sinsation Chocolate Tempering Machine; cutter sets of assorted shapes and sizes, paste food colorings

EASTER BONNET, PART ONE

Steps:

• To make the modeling chocolate: Professionals call modeling chocolate by the name chocolate plastic. Melt the chocolate and cocoa butter over a double boil. Bring the ingredients for the simple syrup to a boil. Place the corn syrup in a bowl and stir in the hot simple syrup. Pour this over the melted chocolate. Stir until it thickens. Place it in the refrigerator for at least one hour. The modeling chocolate will have the consistency of play dough when you work it with your hands. Divide it into three pieces. Use the food color paste to color one piece pink and one piece green. Work the food color paste into the modeling clay to distribute the color until it is the desired color.
• To make the ribbon: Take a ball of each color. Use the palms of your hands to roll each ball into a rope about 1/2-inch thick. Place the ropes side by side and gently press together. Use a rolling pin to roll out the ropes to create a tri-colored ribbon. Use cornstarch to "flour" the work surface. The rolled chocolate should be about 1/8-inch thick. Cut a strip about 30 inches long and about 11/2-inches wide and wrap it around the brim of the hat. You may need to trim the ends.
• To make the leaves and rose petals: Roll out each colored chocolate plastic using cornstarch to "flour" the work surface. The rolled chocolate should be about 1/8-inch thick. To make the flowers, use 2-inch diameter cutter to cut circles from the rolled chocolate. You need to gently thin the top edge of each circle and you can do that with the end of an offset spatula or a hard-boiled egg. Gently press the spatula or egg against the top of the flower to thin the edge (like a real flower petal). Use 11/2 and 2-inch oval cutters to cut out the leaves. You can also do this with a paring knife. Use the back of a paring knife dipped in cornstarch to make the veins of the leaves.
• To make the center: All flowers have some kind of center. Use your fingers to shape a cone-shaped bud for the center of your rose. (Recipe continues on to Part Two)

EASTER BONNET

Steps:

• Recipe courtesy of Jacques Torres (Mrchocolate.com)

NATIVE DRINK

Steps:

• Combine the water with the crushed, strained (if desired) fruit.
• Add the honey and stir. Chill.
• Note: Great cool down for a warm day!