24 Hour Sous Vide Ribs Recipes

SOUS VIDE RIBS

Steps:

• Enjoy.

SOUS VIDE SPARE RIBS

Steps:

• Remove the silver skin from the ribs and break them down into single bones.
• Season generously with the garlic powder, onion powder, salt and pepper.
• Vacuum seal the ribs and either freeze for later or cook right away.
• Fill your cooking vessel with water and place wire racks at the bottom (to allow water to flow under the ribs as they cook).
• Install your immersion circulator and set it to 165 degrees fahrenheit.
• Once the water is up to temperature place the vacuum sealed ribs inside the vessel and then place some kind of weight over them because pork will float. If the ribs float and a portion of them is not submerged during the cook it is not safe to eat the ribs.
• Cover your vessel with a cover if you have it or use aluminum foil. This will help reduce evaporation and loss of water.
• Let the ribs cook for 12 hours if you want a meatier more bite off the bone style ribs, cook a full 24 hours if you want absolutely fall of the bone tender ribs.
• When the cook time is up remove the ribs from the water bath.
• Drain the purge from the bad and remove the ribs from the bag.
• Pat the ribs dry with a paper towel so they don't steam when you put them on the grill. This will make sure you get a nice sear.
• Place the ribs on your preheated grill and pour a little bit of vegetable oil over them. Be careful it will flare up, but that is what we want. This will help you get the char and color on them faster.
• At this point you can add your favorite sauce and grill for a few more minutes or remove them and eat the with "sawsawan" like Dad's family likes to. This is a mixture of soy sauce, spiced white vinegar, garlic and onion.

24 HOUR SOUS VIDE RIBS

Steps:

• First, fill a large pot with water (something large enough to submerge your ribs). Preheat your sous vide water bath to 152ºF by attaching your sous vide to the side of the pot.
• Next, prepare pork dry rub by combining all of the spices together in a medium bowl and set aside.
• Then, remove rack of ribs from the package and place it onto a large baking sheet. Use a sharp knife to cut the rack in half. Then, flip the ribs over and remove the white membrane by peeling it back. Discard membrane.
• Generously season ribs with your dry rub. Use about 1/2 cup of dry rub at this point and save the rest for later. Use your hands to massage the rub into the front and back of the ribs.
• Transfer each half rack of ribs into 2 separate food saver bags and remove as much air as possible and seal. Submerge bags into the sous vide water bath and use 2 clips to attach them to the side of the pot. Cover pot with a piece of tin foil, leaving a hole for the sous vide to stick out. The reason we do this is to prevent evaporation overnight.
• Set timer for 24-hours. Make sure to check water level every so often to make sure that the water does not evaporate. If it does, just add more.
• Once the 24-hours is up, remove bags from water bath and then cut them open with a pair of scissors. Discard the juices and remove the ribs. Place ribs on top of paper towel and use an additional paper towel to blot any moisture out of them.
• Use around 1/4 cup more of dry rub to season the front and back of the ribs. Then, use a brush to apply a layer of your favorite BBQ sauce. You can use as much or as little BBQ sauce as you'd like.
• Preheat grill to 450ºF. Then, rub grill grates with olive oil or spray with nonstick cooking spray. Grill both sides of the ribs for 5-6 minutes or until you get a charred edge.
• Let ribs rest for 5-10 minutes before serving.

SOUS VIDE RIBS

Steps:

• Fill a large temperature-safe water tub 80%.Secure the sous vide machine to the temperature-safe tub. (see machine manual)Set the temperature to 140 degrees and turn the machine on. Tip: The machine is on when the water begins to circulate.
• Rib preparation: Start by rinsing the ribs off under cold water. Pat them dry with a paper towel. Inspect the ribs and cut off anything that looks out of place. Fat hanging, etc.Check and see if the membrane has been removed.The membrane is the silver skin on the underside of the ribs.
• Removing the rib membrane: use the back of a spoon handle. Position it underneath the membrane right by the edge of a rib. Move/position it underneath the surface of the membrane. Then grab a paper towel get a grip on the membrane and pull it back away from the rack of ribs.
• Season the ribs: season the ribs once you get them in the bag. You'll waste nothing this way. Then close the bag and shake.
• Sealing the ribs: two options.1) use a food saver machine and seal and remove the air.2) place the ribs in freezer zip lock bags. With the bag open, lower the bags into the water bath making sure zero water enters the bag.The air in the bag will leave the bag from the pressure of the water. Once the air is removed, seal the bag.
• Secure the bag using a clip to the end of the temperature-safe tub. Secure the bags to the opposite end away from the machine.
• Key step: after 8 hours, lower the temperature to 130 degrees from 140 degrees.Cook for an additional 12 hours. Or so, you can easily do 12 hours, 18 hours, 24 hours, 36 hours, 48 hours. No problem.
• To finish the ribs, place them on a roasting rack. Paint on some of your favorite BBQ sauce and place the ribs under the broiler and give the ribs additional texture. The caramelizing of the BBQ sauce is one of the best parts.

72-HOUR SOUS-VIDE SHORT RIBS

Steps:

• Heat water in a sous-vide water bath to 133 degrees F (56 degrees C).
• Trim any areas of fat left on short ribs; coat thoroughly with garlic and salt. Place ribs into a large, sealable plastic bag. Seal, on low pressure if using a vacuum sealer, removing as much air as possible.
• Submerge bag fully in the water bath and cook, rotating every 12 to 18 hours, for 60 hours. Increase heat to 144.5 degrees F (62.5 degrees C) and cook an additional 12 hours.
• Remove ribs from water bath; let rest in bag on cooling rack placed over baking sheet until cool enough to handle.
• Remove ribs from bag and drain. Turn ribs bone-side up on a work surface and slice meat between bones lengthwise to separate ribs. Cut membrane running along the length of the rib; slide bone loose from the meat. Trim any excess fat and cut into serving portions.
• Pat ribs dry with paper towels; return to cooling rack-lined baking sheet. Heat a skillet until smoking hot; brown ribs quickly, 30 seconds to 1 minute per side.

SOUS VIDE PORK BACK RIBS

Steps:

• Place a heat-resistant pad underneath a large pot filled with water. Attach a sous vide precision cooker to the pot and set temperature to 155 degrees F (68°C).
• Combine brown sugar, kosher salt, smoked paprika, cumin, and cayenne in a small bowl; mix well. Remove rough membranes from the ribs and cut each rack into thirds. Rub spice mixture onto the fleshy side of the meat. Place each rack into a plastic bag and seal.
• Once water temperature has reached 155 degrees F (68°C), submerge both bags in the water. Open the seal of the bags and allow any air to escape. Reseal. Make sure bags are completely submerged. Cover pot with aluminum foil so steam does not escape.
• Set the timer for 24 hours, checking water level occasionally. Add more water of the same temperature water if necessary.
• Set an oven rack about 6 inches from the heat source and preheat the oven's broiler. Line a baking sheet with aluminum foil.
• Remove ribs from the bags and pat dry. Place ribs on the prepared baking sheet and brush with barbecue sauce.
• Broil for 4 minutes. Remove ribs from the oven, brush with more BBQ sauce, and broil until sauce starts to caramelize, about 3 more minutes.

FABULOUS TENDER PORK RIBS - SOUS VIDE STYLE

Steps:

• Preheat the SousVide Supreme to 138F/57°C You can cheat an put them in early because the temperature will drop when you add the ribs. It will come back up to temperature in no time.
• Make Recipe#390416 combining all the dry spice ingredients listed above. You won't use it all. I always quadruple the recipe and store the extra for future use.
• Cut the ribs into sections. I cut into 3-4 bones per section.
• Season both sides of the ribs with the rub mixture. No need to season too heavily as the flavors will be enhanced with this method of cooking. Just a light to moderate dusting. Using your hands, pat the spices into the ribs.
• Put each section into individual vacuum seal bag, removing all the air and sealing. Alternately, arrange the rib sections side by side in the bags and seal DO NOT stack the rib sections in the bag.
• Note: All the air must be removed from the bags to insure the packages are submerged for proper cooking.
• Place bags in the preheated water bath. If you have a rack for your Sous Vide, all the better, if not, do not let them nest. Make sure water passes in between each bag.
• Submerge the pouch(es) in the water oven and cook for a minimum of 24 hours up to a maximum of 48 hours. They will not over cook after 24 hours, really!
• At this point, they are fully cooked. You may cool and refrigerate for several days) or freeze the ribs for future consumption. If you refrigerate them bring to room temperature before grilling. Please note, warming on the grill will take longer because they are hot from the water bath. Note: I have tried cooking & refrigerating for later use.
• Fire up the grill!
• Remove from the pouches from the water bath.
• From this point, finish off the ribs as you normally do.
• Sear the surface of the ribs on the grill, or under the broiler. About 1-2 minutes per side.
• Slather on your favorite BBQ sauce, grilling to achieve caramelization of the sauce.
• Serve & enjoy!