Homemade Chili Meat Using A Pressure Canner Recipes

HOW TO CAN CHILI

Steps:

• While cooking chili, prepare your pressure canner, with 3" of simmering water. Prep jars and lids according to safe USDA canning guidelines.
• Brown ground beef, diced onions and diced green pepper in a large pan until fully cooked. Drain grease and discard. Transfer meat mixture to a very large stockpot.
• Add canned diced tomatoes, kidney beans, chili beans, pinto beans, and black beans to meat mixture. Stir. Add water,spices and Worcestershire sauce. Stir all ingredients well to combine. Cook chili on medium-high until it begins boiling. Give it a taste, and adjust salt, if necessary.
• Fill prepared (clean & hot) canning jars with hot chili, leaving a 1" headspace in each jar. Remove air bubbles with utensil, and adjust headspace, if necessary. Wipe jar rims clean with a wet dishcloth, to ensure a good seal. Center flat lids on top and screw down rings until fingertip tight. Process quart jars at 10# pressure for 90 minutes. If using pint jars, process at 10# pressure for 75 minutes.
• Once processing time is completed, let pressure drop to zero naturally, then follow instructions for safely removing vent and lid. PLEASE follow your pressure canners manufacturer instructions!
• Remove HOT jars of chili, place onto a dish towel on counter (don't place jars directly on counter as temperature variations could lead to cracking the jars). Let jars sit and cool undisturbed overnight. Once completely cooled, check to ensure each jar is properly sealed, wipe down jars, label each one, and store in pantry!

HOMEMADE CHILI WITH MEAT

Steps:

• Brown the beef until almost done, then add chopped onion until brown. Then drain meat.
• Add chopped garlic to mixture and let cook with meat and onion until tender.
• Add remaining ingredients, bring to boil and then let simmer for several hours on stove or in a slow cooker.
• Serve with cheese and chives on top or over a baked potato the next day!

HOME CANNED CHILI

Steps:

• Wash dried beans. Place in large pot, cover with about 5 to 10 cm (2 to 4 inches) of water, let stand overnight or 12 to 18 hours.
• Drain, discard soaking water.
• Put in large pot, cover with fresh water (optional: add a few bay leaves), bring to a boil, then lower to a simmer covered for 30 minutes.
• Meanwhile, combine ground beef, onion and pepper, and fry until beef is browned. Drain in a mesh strainer, colander or on paper towel to get excess grease off.
• Drain beans (tip: you can freeze the bean stock as a base for delicious soups).
• Return beans to their large pot, and add the beef mixture, the tomatoes, and all the flavourings. Stir, bring to a boil, then lower to simmer for 5 minutes to ensure all is heated through evenly.
• Pack into heated jars: either 1/4 litre or 1/2 litre (1/2 US pint or 1 US pint), leaving 3 cm (1 inch) headspace.
• Debubble; adjust headspace.
• Wipe jar rims.
• Put lids on.
• Processing pressure: 10 lbs (69 kPa) weighted gauge, 11 lbs (76 kpa) dial gauge (adjust pressure for your altitude when over 300 metres / 1000 feet.)
• Processing time: Process either size of jar for 75 minutes .

PRESSURE COOKER BEEF CHILI

Steps:

• Heat 1 tablespoon vegetable oil in a skillet over medium-high heat. Season beef generously with salt and black pepper; place meat in the skillet and cook until brown on all sides, 5 to 10 minutes. Transfer to plate and set aside.
• Heat 1 tablespoon vegetable oil over medium-low heat in the pot of a pressure cooker. Stir onion and garlic into pot; cook until almost translucent, 4 to 6 minutes. Stir in ancho chile powder, paprika, cumin, black pepper, chipotle chile powder, cayenne pepper, and oregano; cook until fragrant, 2 minutes. Add diced tomatoes, beef, and water; stir to combine.
• Lock the lid of your pressure cooker. Increase heat to high and bring to full pressure. Reduce heat to low to maintain pressure; cook for 15 minutes. Remove from heat and let rest 10 minutes. Ensure that pressure is fully released and remove the lid.
• Return uncovered pressure cooker to burner over high heat. Stir in corn chips and bring to a boil; cook for 5 minutes. Garnish with cilantro and green onion.

PRESSURE COOKER CHILI

Steps:

• Place the ground beef in the pressure cooker over medium high heat; cook until brown and crumbly, 8 to 10 minutes. Remove the ground beef, and drain off the excess fat.
• Return the open pressure cooker to the burner over medium heat, pour in the olive oil, and stir in the onion, green pepper, and jalapeno pepper. Cook and stir for 3 to 4 minutes, until the onion is translucent. Add the garlic, and cook and stir for about 30 more seconds. Return the meat to the pressure cooker; mix in the kidney beans, diced tomatoes, tomato paste, brown sugar, cocoa powder, red pepper flakes, chili powder, cumin, salt, and water.
• Lock the lid, bring the cooker up to pressure, reduce heat to maintain pressure, and cook for 8 minutes. Remove cooker from the heat, and let the pressure reduce on its own, 5 to 10 minutes.
• When the pressure is fully released, remove the lid, stir the chili, and serve.