Roasted And Reverse Seared Prime Rib Recipes

REVERSE-SEAR PRIME RIB ROAST

Steps:

• Season roast generously with kosher salt. Cover loosely with plastic wrap and refrigerate, 8 hours to overnight.
• Remove roast from refrigerator and allow to come to room temperature, about 2 hours.
• Preheat oven to 200 degrees F (95 degrees C).
• Mix butter, rosemary, thyme, and black pepper together in a small bowl; spread butter mixture over roast. Place roast in a large roasting pan.
• Bake roast in the preheated oven until internal temperature reaches 115 degrees F (46 degrees C) for medium-rare, about 3 1/2 hours. Remove from oven and tent with aluminum foil; allow to rest, about 20 minutes.
• Increase oven temperature to 500 degrees F (260 degrees C). Uncover roast.
• Return roast to the oven and bake until well-browned, 6 to 10 minutes. Slice and serve.

ROASTED AND REVERSE SEARED PRIME RIB RECIPE

Steps:

• Remove roast from oven and tent loosely with aluminum foil. Place in a warm spot in the kitchen and allow to rest for at least 30 minutes and up to 1 1/2 hours. Meanwhile, preheat oven to highest possible temperature setting, 500 to 550°F (260 to 288°C).
• Ten minutes before guests are ready to be served, remove foil, place roast back in hot oven, and cook until well-browned and crisp on the exterior, 6 to 10 minutes. Remove from oven, carve, and serve immediately.

CLASSIC PRIME RIB (REVERSE SEAR)

Steps:

• Preheat oven to 250F/121C.
• PREPARE ROAST: Pat roast dry with paper towel. Insert garlic slivers into roast all over between meat and fat (separate with fingers and slip in garlic). Leave the fat cap on the top of the meat for great flavor. If using Dijon, smear it all over roast. Season roast liberally with kosher salt and black pepper. Sprinkle on thyme if using. Place roast, bone side down, in shallow pan lined with foil (for easier clean up). If you have a temperature probe, insert it in the center of the roast. If not use an instant-read thermometer.
• START ROASTING AT LOW TEMP: Roast in oven, fat side up, at 250F/121C for about 2 to 2 1/4 hours or until internal temperature reaches 120F/49C for medium rare on instant thermometer (you'll be cooking it longer later on). Or 130F/54.4C for medium. Remove roast, cover loosely with aluminum foil and let it rest for at least 30 minutes and up to 90 minutes.
• FINISH ROASTING AT HIGH TEMP: While roast is resting, increase oven temperature to 500F/260C. 10 minutes before you're ready to serve, place roast in hot oven. Roast for 6-10 minutes (or a bit longer if roast is bigger) until exterior browns nicely. Insert meat thermometer to check temperature of meat - it should rise to 130F/54.4C for medium rare. Or 140F/60C for medium measured with an instant-read thermometer. Note 2 for internal temperatures.
• SLICE AND SERVE: On cutting board, turn roast on side and slice off bones. Then turn meat, cut side down, on board and slice. Remove garlic slivers. Serve immediately with gravy or au jus.

REVERSE-SEARED INSTANT POT PRIME RIB AND GRAVY

Steps:

• Make 4 evenly spaced small slits about 1/2 inch deep on the top of the roast with a small paring knife. Put a few rosemary leaves on top of each slit and push them in using a piece of garlic. Repeat on the other side of the roast. Make two slits on the ends of the roast and stuff with the remaining rosemary and garlic.
• Combine 5 teaspoons salt and 1 tablespoon pepper in a small bowl and stir to combine. Sprinkle all over the roast, firmly pressing the mixture onto the exterior and stuffing some into the slits.
• Place the trivet in the bottom of the insert of a 6-quart Instant Pot®. Pour in the beef broth and 1/4 cup of the wine. Place the roast on the trivet, fat-side up, then set it to pressure cook on low for 10 minutes with the keep warm feature turned on (see Cook's Note). Once the pressure cook cycle ends let the pot stand, closed, for 45 minutes. Open the lid and transfer the roast to a plate. Remove the trivet and pour the broth into a heatproof container. Rinse the insert and return it to the machine.
• Set the machine to sauté and add the butter. Once the butter is melted and foamy add the roast and sear until dark brown on all sides and an instant-read thermometer inserted into the center of the roast registers 120 degrees F for medium rare, about 4 minutes per side. Transfer the roast to a cutting board and let rest for 15 minutes before slicing.
• Meanwhile, immediately add the remaining 1/4 cup wine to the insert, scraping up the browned bits that are stuck to the bottom. Continue to cook until almost all the wine has evaporated then sprinkle in the flour. Stir until a uniform paste forms then whisk in the reserved broth. Bring to a boil and simmer until the flavor of the flour has cooked out, about 5 minutes. Adjust the seasoning, if needed, and whisk in a bit more beef broth if the gravy becomes too thick. Strain through a mesh strainer into a gravy boat and stir in the herbs right before serving. Serve alongside the roast.