Soft Maple Sugar Candy Recipes

PURE MAPLE CANDY

Steps:

• In a large heavy-bottomed saucepan, bring the maple syrup to a boil over medium-high heat stirring occasionally. Boil until syrup reaches 235 degrees F (110 degrees C) on a candy thermometer.
• Remove from heat and cool to 175 degrees F (80 degrees C) without stirring, about 10 minutes.
• Stir mixture rapidly with a wooden spoon for about 5 minutes until the color turns lighter and mixture becomes thick and creamy. Stir in chopped nuts, if desired.
• Pour into molds. Set aside to cool. Once cool, unmold candy. Store in airtight containers up to 1 month.

MAPLE LEAF CANDY

Steps:

• Gather the ingredients.
• If you are using candy molds, prepare by spraying them lightly with nonstick cooking spray.
• Take a paper towel and wipe off most of the spray; you want just a very thin coating of nonstick spray on the inside.
• Pour the syrup into a medium, heavy-bottomed saucepan and place it over medium heat. (The syrup will bubble up quite a bit, so make sure that the saucepan is large enough so that it will not easily boil over the top.)
• Bring the syrup to a boil; this can take about 15 to 20 minutes.
• Insert a candy thermometer and add the butter.
• Stir until the butter is fully melted and incorporated.
• Continue to cook the mixture until it reaches 240 F on the candy thermometer ( soft-ball stage ), about 35 to 40 minutes.
• Remove from the heat and allow it to cool for 2 to 3 minutes.
• Stir the candy vigorously with a wooden spoon until it thickens, lightens in color, and turns opaque, which should take about 3 to 5 minutes. Stop stirring once it reaches this point because if you continue to stir, it will start to set in the pan and become difficult to pour into the molds.
• Working quickly, spoon the candy into the candy molds.
• Smooth the tops with a small offset spatula.
• Once the candy is poured, it will start to set quickly. Let it sit at room temperature for about 10 minutes.
• Pop them out of the molds.

SOFT MAPLE SUGAR CANDY

Steps:

• heat maple syrup to a temperature of approximately 32-34oF above the boiling temperature of pure water (212 degrees F at sea level).
• pour the syrup into a flat pan or trough and allow it to cool undisturbed to at least 200F but not less than 160°F.
• stir until the syrup is soft and plastic.
• pour or pack it into molds. Molded candies commonly set up in 10 to 30 minutes. Candies formed by pouring rather than packing will have an attractive glazed surface.

MAPLE CANDY

Steps:

• Line the bottom and sides of a 9-by-5-inch loaf pan with parchment paper; brush the parchment with vegetable oil. Bring the maple syrup to a boil in a large saucepan over medium heat, then reduce the heat to medium low. Dip the back of a spoon in vegetable oil and run it over the top of the foam to help it subside. Increase the heat to medium and continue cooking until a candy thermometer registers 246 degrees F, 25 to 30 minutes. Pour the syrup into a heatproof bowl and let cool, 5 minutes.
• Beat the syrup with a mixer on medium-low speed until it starts to lighten in color and turn opaque, 30 seconds to 1 minute. Pour into the prepared pan and spread with an offset spatula; let cool completely, about 1 hour. Lift out of the pan and cut into pieces.

MAPLE SYRUP CANDY

Steps:

• Cook syrup in a saucepan over medium heat until it reaches 240 degrees on a candy thermometer.
• Remove from heat and allow to cool to 200 degrees.
• Stir constantly until syrup becomes sugary.
• Pour into molds (something about the size of a caramel candy).
• When candy is cool, you can remove from molds.

HARD MAPLE CANDY

Steps:

• Grease a 15x10x1-in. pan with butter; set aside. In a large heavy saucepan, combine the sugar, corn syrup and water. Cook over medium-high heat until a candy thermometer reads 300° (hard-crack stage), stirring occasionally. , Remove from the heat; stir in maple flavoring. Immediately pour into prepared pan; cool. Break into pieces. Store in an airtight container.