Fall Apart Pressure Cooker Pot Roast Original Recipes

PRESSURE COOKER POT ROAST RECIPE

Steps:

• Season the meat with salt and pepper on both sides.
• Preheat the pressure cooker (I used my Instant Pot - affiliate link), select saute on high. Add in the oil.
• Once the pot is hot, brown the chuck roast, 3-4 minutes on each side. Transfer the meat onto a plate and cover with foil (or parchment paper) to keep warm.
• Add in the onion, garlic, chicken stock, and thyme and give it a stir.
• Put the meat back into the pot and secure the lid.
• Select manual, make sure that the steam release handle is turned to sealing position, and cook at high pressure for 60 minutes.
• When cooking is complete, use natural release for 10 minutes and then release the remaining steam.
• Add in the potatoes, carrots, and parsnips. Be sure to submerge them in the cooking liquid.
• Select manual and cook at high for 10 minutes.
• When cooking is complete, use a natural release for 10 minutes and then release the remaining steam.

PRESSURE COOKER POT ROAST

Steps:

• Bring chuck roast to room temperature, then season well with salt and pepper.
• Heat the Instant Pot using the sauté setting. Once hot, add oil, then sear roast on both sides. Set aside.
• Add 1 onion and celery to pot and cook for 2 minutes, until soft and translucent. Then add garlic, thyme, rosemary, and bay leaf - continue cooking for 1 minute.
• Add red wine to deglaze the pot, making sure to scrape up all bits. Let wine simmer for at least 2 minutes.
• Add roast, then add enough broth so that the roast is just barely covered.
• Lock lid and cook for 75 minutes at high pressure. Once time is complete, let pressure naturally release (about 30 minutes).
• Carefully remove roast and set aside to rest.
• Using a fine mesh strainer, pour liquid into separate container, then return to pot. Discard aromatics.
• Add sliced onion, carrots, and potatoes to pot and close lid.
• Lock lid and cook for 4 minutes at high pressure, then quick-release pressure.
• Meanwhile - In a small dish, combine cornstarch and water. Once cook time is complete, open lid, switch to sauté setting, and add cornstarch slurry to pot. Cook until desired consistency is achieved (2-3 minutes).
• Return roast to pot and pull apart meat as much as you like.
• Serve together and enjoy!

FALL-APART PRESSURE COOKER POT ROAST ORIGINAL

Steps:

• Turn Instant Pot to Saute. Add the oil.
• When shimmering, add the pot roast. Cook 2-3 minutes to golden, then flip to sear other side.
• Sprinkle on the sea salt. Top with sliced onion. Pour in the water or broth.
• Close and lock the lid. Set Instant Pot to "Manual" and program for 70 minutes.
• You may do quick release or natural release.

PERFECT PRESSURE COOKER POT ROAST

Steps:

• Heat oil in the pressure cooker over medium-high heat with the lid open. Brown the roast on all sides in the hot oil.
• In a small cup or bowl, mix together the Italian salad dressing mix, Ranch dressing mix, and gravy mix. Sprinkle them evenly over the roast. Pour in the beef broth and add the chopped onion.
• Seal and lock pressure cooker, and cook over high heat to build pressure until the indicator sounds (mine whistles). Turn heat down to medium, and cook for 45 minutes. Remove from heat and let stand for 5 minutes. Run under cold water to help release the pressure before unsealing the lid. You can use the juices as an au jus, or thicken with flour or cornstarch to make a yummy gravy.

EASY PRESSURE COOKER POT ROAST

Steps:

• Heat oil in a pressure cooker over medium-high heat. Brown roast on all sides in the hot oil; season with pepper, seasoned salt, and onion powder.
• Pour in beef broth and Worcestershire sauce, add the quartered onion, and seal the lid. Bring the cooker up to full pressure. Reduce heat to low, maintaining full pressure, and cook for 30 minutes.
• Use the quick-release method to lower the pressure. Mix in carrots and potatoes, seal the lid again, and return the pressure cooker to the heat. Bring the cooker up to full pressure and cook for an additional 15 minutes. Use the quick-release method again and transfer the roast and vegetables to a serving dish.

PRESSURE COOKER POT ROAST

Steps:

• Season the beef generously all over with about 1 tablespoon salt. Using the sauté setting, warm the oil in a 6- to 8-quart electric pressure cooker. Add one chunk of the beef and sear one side until deeply browned, about 5 minutes. Remove the first chunk and repeat with the remaining chunk, searing one side. (You can brown more than one side of each chunk, but one side is enough to build flavor without spending too much time on this step.) If the pressure cooker gives you a "hot" error, simply turn it off and use residual heat to cook. When it cools, turn the sauté setting back on.
• Add the pearl onions and garlic; season with salt and pepper. Cook, stirring, until the garlic is softened, about 2 minutes. Pour in the wine, vinegar and 1/2 cup water; season generously with black pepper and lightly with salt. Using a metal or wooden spoon or spatula, scrape up all the browned bits on the bottom of the pot. Turn off the sauté setting. Add the herbs and nestle the beef into the liquid. Cook on high pressure for 1 hour.
• Make the pickled onions, if desired: Bring the vinegar and sugar to a boil in a small saucepan. Add the pearl onions and a generous pinch of salt and cook, stirring, to dissolve the sugar and warm the onions through, about 1 minute. Remove the mixture from heat and set aside at room temperature to pickle for at least 1 hour. (You can make the pickled onions up to 5 days ahead; store them in a sealed container in the refrigerator.)
• Allow the pressure to reduce naturally for 10 minutes, then release the remaining pressure manually. Add the vegetables to the pot, tucking them below the liquid. Cook on high pressure until the beef and vegetables are both tender, an additional 4 minutes. Quick-release the pressure by twisting the pressure knob to vent, then open the lid. Using tongs and a slotted spoon, remove the beef and vegetables to a serving platter. Break the beef into large chunks to serve. At this point, you can simply drizzle some cooking liquid over the top of the beef and vegetables, and top with the drained, pickled pearl onions to serve. Discard the remaining cooking liquid or strain it, refrigerate it, discard the layer of fat and freeze the remaining liquid as beef stock.
• If you'd prefer a thicker gravy, strain the cooking liquid and return it to the pot. Using the sauté function, bring it to a boil. Meanwhile, combine the butter and flour in a small bowl and knead it together with your fingers until it is uniform, almost like a dough. Once the liquid is boiling, drop the butter-flour mixture into the pot, whisking well to combine. Let it bubble until it is lightly thickened, about 5 minutes, then drizzle some gravy over the pot roast and vegetables, and top with drained, pickled onions. Serve extra gravy on the side.