Basicmachinefrenchbread Recipes

BASIC MACHINE FRENCH BREAD

Steps:

• Add to the bread pan in the order yours needs.
• For mine it is water first.
• Then I add half the flour and the salt followed by the rest of the flour and the yeast on top.
• This will run well on the normal, rapid, and delay start cycles.

BREAD MACHINE FRENCH BREAD (SIMPLE, SIMPLE, SIMPLE)

Steps:

• put in machine in order and push buttons to make a 1.5 Lb french loaf.

BREAD MACHINE CRUSTY FRENCH BREAD

Steps:

• Gather the ingredients.
• Add the room temperature water, oil, dry milk, all-purpose flour, bread flour, sugar, salt, and yeast to the bread machine according to your manufacturer's preferred order.
• Use the French bread setting on your machine but remove the dough after the last kneading cycle before the baking cycle begins. Or use the dough cycle, punch down the dough to let air escape, let it rise again (45 minutes to 1 hour), knead lightly, and let it rise again (another 45 minutes to 1 hour) before forming into loaves.
• Spray or lightly oil a large cookie sheet and sprinkle with the cornmeal.
• To form the loaves, transfer the dough (it will be soft) to a lightly floured board. Sprinkle with a little all-purpose flour.
• Cut the dough into 2 portions and roll each portion into a rectangle about 12 to 15 inches wide (add more flour as needed).
• Starting at the long end, roll up the dough, pinching the seams well. Repeat with the next roll.
• Place the loaves on the prepared cookie sheet; cover with a clean dishtowel and let rise another hour.
• While the loaves are rising, preheat the oven to 400 F. Place a pie plate on the lower rack of the oven and add about 1 inch of boiling water. Place the pan with the dough on the middle rack and bake the bread for 15 minutes.
• Lower the heat to 350 F and bake for another 25 minutes until golden brown.
• About 5 minutes before the loaves are done, mix the egg white with the cold water in a small bowl and brush the loaves with the egg wash .
• Once baked, remove from the oven and let cool.
• Serve and enjoy.

FRENCH BREAD

Steps:

• In a large bowl, combine 2 cups flour, yeast and salt. Stir in 2 cups warm water, and beat until well blended using a stand mixer with a dough hook attachment. Using a wooden spoon, stir in as much of the remaining flour as you can.
• On a lightly floured surface, knead in enough flour to make a stiff dough that is smooth and elastic. Knead for about 8 to 10 minutes total. Shape into a ball. Place dough in a greased bowl, and turn once. Cover, and let rise in a warm place until doubled.
• Punch dough down, and divide in half. Turn out onto a lightly floured surface. Cover, and let rest for 10 minutes. Roll each half into large rectangle. Roll up, starting from a long side. Moisten edge with water and seal. Taper ends.
• Grease a large baking sheet. Sprinkle with cornmeal. Place loaves, seam side down, on the prepared baking sheet. Lightly beat the egg white with 1 tablespoon of water, and brush on. Cover with a damp cloth. Let rise until nearly doubled, 35 to 40 minutes.
• With a very sharp knife, make 3 or 4 diagonal cuts about 1/4 inch deep across top of each loaf. Bake in a preheated 375 degrees F (190 degrees C) oven for 20 minutes. Brush again with egg white mixture. Bake for an additional 15 to 20 minutes, or until bread tests done. If necessary, cover loosely with foil to prevent over browning. Remove from baking sheet, and cool on a wire rack.

BEST BREAD MACHINE BREAD

Steps:

• Place the water, sugar and yeast in the pan of the bread machine. Let the yeast dissolve and foam for 10 minutes. Add the oil, flour and salt to the yeast. Select Basic or White Bread setting, and press Start.