Easterbunnycake Recipes

EASTER BUNNY CAKE

Steps:

• Heat oven to 350°F (325°F for dark or nonstick pans). Make, bake and cool cake as directed on box for two 8-inch or 9-inch round pans.
• Reserve 1 layer for another use or to make a second bunny. Cut 1 layer in half as shown in diagram. Put halves together with frosting to make body. Place cake upright on cut edge on tray.
• Cut out a notch about one-third of the way up one end of body to form head (small end) as shown in diagram. Attach half of cutout piece from tail with toothpicks. Frost with remaining frosting, rounding body on sides. Sprinkle with 1 cup coconut. Cut ears from construction paper; wrap ends that will be inserted into cake with plastic food wrap. Press into notch on top. Use jelly beans for eyes and nose.
• Shake 1 cup coconut and 3 drops food color in tightly covered jar until evenly tinted. Surround bunny with tinted coconut. Add additional jelly beans if desired. Remove ears, plastic wrap and toothpicks before serving. Store loosely covered.

EASTER BUNNY CAKE

Steps:

• Preheat the oven to 350 degrees F.
• Butter and flour the metal bowls. Combine the cake mix, water, oil, and eggs in another clean bowl. Beat for 2 minutes or until well blended. Pour 2 cups of batter into the smaller prepared bowl; pour remaining batter into larger prepared bowl. Bake smaller cake for 40 minutes and larger cake for 45 minutes, or until toothpick inserted into the center of the cake comes out clean. Cool cakes on cooling rack for 30 minutes. Invert cakes onto cooling rack and cool completely.
• Cut larger cake in half, forming 2 half-moon pieces. Spread 1/4 cup of frosting over flat top of each piece. Place pieces cut side down on work surface, adhering frosted sides together. Trim 1-inch from 1 end of the cake; discard trimmings. Repeat with the smaller cake. Place larger cake on a serving platter. Spread 2 tablespoons of frosting over trimmed end of smaller cake. Place trimmed end of smaller cake against trimmed end of larger cake. Spread remaining frosting over cakes to cover completely. Sprinkle with all but 1/2 cup of the coconut, pressing to adhere.
• Brush melted milk chocolate over both sides of the cookie halves to coat completely. Sprinkle with reserved 1/2 cup coconut; set aside to dry. Press 2 semisweet chocolate morsels onto bunny face for eyes. Using toothpicks, secure jellied candy onto bunny face for nose. Using toothpicks, secure licorice pieces onto face for whiskers. Using toothpicks, secure miniature marshmallows onto bunny face for teeth. Make 2-inch deep cuts atop bunny head; insert chocolate cookie halves for ears. Roll large marshmallows together; using toothpick, secure onto bunny for tail.

EASTER BUNNY CAKE

Steps:

• For the frosting: Combine the sugar, butter and salt in the bowl of a stand mixer fitted with a paddle attachment (or in a large bowl if using a hand-held electric mixer). Mix on low speed until mostly incorporated. Add the vanilla, increase the speed to medium high and mix until smooth. Adjust the consistency with milk until the frosting is easy to spread.
• For the bunny: Spread a thin layer of frosting (about 2/3 cup) on the flat side of one cake layer and top with the flat side of the second cake layer. Measure 5 inches across the top of the cake and cut down through the layers, creating 2 layered pieces that are slightly different sizes.
• Place the larger piece of cake cut-side down on a large platter or cake board. If using a rectangular cake board, place the larger piece so that the long edges are parallel with the long edges of the board. This is the body of the bunny. Cut the smaller piece of cake in half crosswise, so you have 2 layered wedges. Place one wedge in front of the body, with one flat side on the board and the other flat side against the body. The curved side will be on top. Take a serrated knife and round off the sharp edges on top of the head. Cut the tip off (the nose) at a 45-degree angle. Reserve all scraps in a bowl.
• Separate the layers of the remaining wedge of cake. These will be the back legs. Round the sharp edges of the cake wedges with your knife and add to the scrap bowl. Place one piece on each side of the bunny, with one flat side down and the other flat side facing forward (the round side towards the back of the bunny), about 1 inch from the end of the bunny's body.
• Mix the cake scraps in the bowl with a fork until mashed and then pack into a ball with your hands. Place the ball behind the bunny's body and adhere with a dab of frosting. This is the bunny's tail.
• Frost the entire bunny, tail and all, using 2 to 3 cups of the frosting, keeping some definition with the bunny parts and frosting more generously around any sharp edges to give a rounded look to the bunny parts. Sprinkle the bunny with the coconut to fully cover. Gently pat to adhere.
• Insert the biscotti between the head and body, pressing into the cake to secure them. These are the ears. Place the base of the ears close together at the center of the head and angle them out. Frost the front of each biscotti with some frosting. Then, using the pink decorating icing, frost a smaller strip in the center of each biscotti, going down to where the ears meet the head but not going all the way to the top.
• To make the face, press a black jelly bean into each side of the head for the eyes. Cut one of the marshmallows into 3 circles, discard the middle piece and press the 2 end circles, cut-sides in, into the front of the face for the bunny cheeks. Push the white jelly bean halves into the face below the cheeks, round-sides out, for the teeth. Place the pink jelly bean above for the nose.
• Unroll the licorice wheel and cut 2 pieces, each about 1 1/2 inches long. For each piece, peel the strips apart halfway down and then cut each separated strip in half lengthwise so you end up with a piece looking a bit like a broom. Repeat with the second piece of licorice. Tuck each piece, with a dab of frosting, behind a marshmallow cheek, with the cut ends facing out for the whiskers.
• Cut the second marshmallow in half lengthwise. Make 3 slits in each half, going about halfway through (these are the toes), and place in front of the legs for the bunny's feet. Adhere the bottom of the feet with frosting if necessary.

EASTER BUNNY CAKE

Steps:

• Prepare cake mix according to directions on box for 2 round 9" layers.
• Tint 1/4 cup of the coconut pink (I'm guessing at the amount) for the center of ears and feet.
• Tint 2 tablespoons of the frosting brown for decorating face and feet ( or you can buy one of those prepared decorating icing tubes).
• When cake is cool, cut layers as shown in diagram (see other photo).
• Take 4 of the 8 outer ring pieces and frost the tops. Place 1 of the remaining 4 on top of each and frost top and sides. These will make the feet of the bunny.
• Place round-cut center piece next to the top edge of the square, keeping them both flat, to form body and head.
• Assemble the 4 side pieces in twos, flat sides together (you can use a little frosting to hold them together) to form the ears and arrange at the top of the head.
• Frost entire cake and attach the completed feet, 2 on each side of the body.
• Sprinkle coconut over entire cake and decorate with jelly beans/gumdrops for eyes, nose, etc. as desired, using pink-tinted coconut for center of ears and feet.
• Here's where you can really have fun and get creative! You can tie the ribbon in a bow and place on the cake as a bowtie, make buttons out of the candy, add a hat, etc.
• ** Tip for using frosting to decorate without a pastry bag: Spoon the frosting into one corner of a small plastic sandwich baggie, twist tightly and snip off the tip of the corner. Voila!
• Note: The finished cake is almost 2 feet long so be sure to have it on a large enough cookie sheet or platter!
• Servings vary on how you decide to divide up the body (er, bunny) parts -- .

EASY BUNNY CAKE

Steps:

• Heat oven and prepare two 9 inch round baking pans as directed on cake box. Prepare cake batter with as directed on package adding in 1/2 cup of coconut. Divide batter evenly between the prepared pans. Bake and cool cake as directed on package.
• When cooled, place one whole 9 inch cake layer on serving tray, forming the bunny's head. Cut 2 convex shaped ears from each side of the second layer, place on each side of head to form ears. Use concave shaped piece for the bowtie, place about 1/2 inch below head.
• Frost entire bunny covering top and sides of bunny. Pat remaining 3 1/4 cup coconut evenly over top and sides. Decorate the bunny face and bowtie with jellybeans and use the licorice to make whiskers.