Onion Ring Batter Recipes

BATTER FRIED ONION RINGS

Steps:

• Cover onion slices with cold water and let stand 30 minutes.
• Remove to paper towels and press to dry.
• Separate into rings.
• Combine flour, sugar and salt.
• Combine milk and egg in a medium bowl and add dry ingredients and melted shortening; mix thoroughly.
• Dip onion rings in batter and fry in deep fryer or skillet filled with a couple of inches of oil until golden brown on both sides.
• Remove and drain on paper towels.
• Serve immediately.

HOW TO MAKE ONION RING BATTER

Steps:

• Sift the flour into a large mixing bowl. Add a pinch of salt. Make a well in the center of the sifted flour.
• Tip the egg yolks and oil into the well. Use a large spoon or electric mixer to mix until smooth. Gradually add the milk while mixing, and beat well.
• Cover the batter. Let stand for 30 minutes in the refrigerator, to chill. While the batter is sitting, slice the onion rings to about 1/2 inch/1cm thickness.
• After 30 minutes, whisk the egg white until stiff. Fold into the batter.
• Dip the onion rings into the batter and fry until golden brown. This will take about 3-4 minutes.
• Remove from the oil using tongs or a slotted spoon. Place on kitchen paper to remove any excess grease, then serve immediately.

BEST EVER ONION RINGS

Steps:

• Whisk together eggs, milk, flour, baking powder, and onion salt in a bowl to make a smooth batter.
• Heat the oil in a large saucepan or deep fryer until a thermometer reads 350 degrees F (175 degrees C).
• Dip the onion rings evenly into the batter, then fry in the oil for 2 to 3 minutes, working in batches if necessary, until the onion rings are golden brown. With a slotted spoon, remove the onion rings to paper towels to drain. Serve hot.

FANTASTIC ONION RING BATTER

Steps:

• Soak onion rings in a bowl of ice water for 1 hour; drain and pat dry with paper towels.
• Whisk 1 cup plus 2 tablespoons flour, milk, egg, 2 tablespoons vegetable oil, and salt together in a bowl until smooth.
• Heat oil in a deep-fryer or large saucepan to 375 degrees F (190 degrees C).
• Dip onion rings in the batter, working in batches, until evenly coated and arrange in 1 layer on a plate.
• Fry the battered onion rings, working in batches, until browned, about 5 minutes. Transfer fried onion rings to a paper towel-lined plate using a slotted spoon.

BEER-BATTERED ONION RINGS

Steps:

• Whisk together the flour, granulated garlic, cayenne and 1 tablespoon each salt and black pepper in a large bowl until well blended. In a separate large bowl, whisk together the buttermilk, milk and beer.
• Dunk the onion rings in the beer mixture and then toss in the flour mixture to coat evenly. Shake off the excess flour and lay the rings on a baking sheet. Let sit for 30 minutes.
• Meanwhile, fill a heavy pot with 3 inches of vegetable oil and heat to 350 degrees F. Sift the flour mixture to remove any clumps.
• Dunk the onions a second time in the buttermilk and toss in the flour. Shake off any excess flour before dropping the rings into the hot oil. Fry until golden, 1 to 2 minutes per side. Drain on paper towels. Serve with your favorite dipping sauce.

DO AT HOME ONION RINGS

Steps:

• Mix egg, oil, and milk on low speed of mixer for 1 minute.
• Add dry ingredients and mix until smooth.
• Coat onions in flour.
• Dip in batter.
• When one side is golden turn to the other side.
• Fry in hot oil 375* until desired shade of brown.

BEER-BATTERED ONION RINGS BY MARTHA STEWART RECIPE BY TASTY

Steps:

• In a large pot over medium-high heat, bring 3 inches (8 cm) of oil to 375˚F (190˚C).
• Peel and cut onions crosswise into ½ (1 ⅓ cm) inch slices.
• Separate into rings and place in a large bowl with ice water while you prepare the batter.
• In a medium mixing bowl, whisk together 1 cup flour (125 g), salt, white pepper, and baking powder.
• Whisk in beer and 2 tablespoons of ice water until just combined.
• In a separate bowl, add the remaining 1 cup (125 g) of flour.
• Remove the rings from the ice water bath and pat dry. Coat the rings first in the flour then in the batter, allowing any excess to drip off.
• Working in batches, transfer battered rings to hot oil to cook for 2 to 3 minutes, or until golden brown.
• Transfer to a paper towel lined rack to drain. Sprinkle with salt.
• Enjoy!

ONION RINGS

Steps:

• Use a fork to steady your onion. Slice the onion into rings about 1cm wide. Remove the skin and separate the rings.
• Heat the oil to 180C in a heavy-based pan - it should be no more than 1/ 3 full.
• Meanwhile put the flour and sparkling water in a bowl and season generously. Whisk together to form a batter.
• Coat a small batch of onion rings in batter. Carefully lower into the hot oil and deep-fry until crisp and golden, about 2 - 3 minutes. Remove with a slotted spoon and place on a piece of kitchen towel to drain. Repeat with the remaining onion and batter.

CRISPY FRIED ONION RINGS

Steps:

• In a shallow bowl, whisk the first 5 ingredients. Separate onion slices into rings. Dip rings into batter. In a deep-fat fryer, heat 1 in. of oil to 375°. In batches, fry onion rings until golden brown, 1 to 1-1/2 minutes on each side. Drain on paper towels. Serve immediately.

BEER BATTERED ONION RINGS

Steps:

• In a shallow bowl combine flour, egg, parsley, garlic powder, oregano, salt and pepper. Gradually add beer, stirring, until a thick batter forms. Add more or less beer depending on the desired consistency of the batter.
• In a heavy frying pan heat oil (adjust amount, depending on the size of your pan, so that you have a couple of inches of oil) over medium-high heat. When oil is hot, dip onions in batter and fry, turning once to brown evenly on both sides. Drain on paper towels.

ONION RING BATTER

Steps:

• Blend all ingredients well.

ONION RINGS

Steps:

• Heat the oil in a large, deep skillet over medium high heat.
• Prepare pancake mix according to package directions.
• One at a time, dip Spanish onion rings into the prepared pancake batter, then into the hot oil. Fry until crispy and browned, about 3 minutes. Drain on paper towels.

ONION RINGS

Steps:

• Line a baking sheet with paper towels; set aside. Place onion rings in a large bowl of ice water for 10 minutes; drain and pat dry. In a large bowl, whisk together flour, cornstarch, baking powder, salt, and seltzer.
• In a heavy 5-quart pot or Dutch oven, heat oil over high until a deep-fry thermometer registers 375 degrees. Working in 7 to 8 batches, place onions in batter; using your fingers, lift out, letting excess drip off. Carefully place in oil, making sure not to overcrowd pot; cook until golden brown, 2 to 3 minutes.
• Transfer rings to prepared baking sheet, and season with salt. Keep warm in a 250-degree oven. Return oil to 375 degrees before starting next batch.
• Once all the onion rings are done, place on a platter. Very carefully place parsley in pot (oil will spatter), and fry until crisp, 10 seconds; remove, using a spider or slotted spoon, and season with salt. Sprinkle onions with parsley.

BEER BATTER ONION RINGS

Steps:

• Put the flour into a bowl and make a well in the center.
• Pour the beer into the well and whisk until combined.
• Let rest, covered for 1 hour.
• Peel onions and cut crosswise 1/3 inch thick and separate into rings.
• Dust the onion rings with the additional flour, shaking off the excess, and coat them with the batter.
• Working in batches, fry the onion rings in 2 inches of preheated 370 degrees, oil until they are golden.
• Transfer them with a slotted spoon to paper towels to drain and sprinkle them with salt to taste.

BUTTERMILK BATTER-FRIED ONION RINGS

Steps:

• Cut onions into 1/2-inch slices, and separate into rings.
• Set aside.
• Whisk together flour and next 4 ingredients until smooth.
• Pour oil to a depth of 2 inches into a Dutch oven; heat to 375°.
• Dip onion rings in batter, coating well.
• Fry, a few rings at a time, until golden.
• Drain on paper towels.
• Serve immediately.

OLD FASHIONED ONION RINGS

Steps:

• Heat the oil in a deep-fryer to 365 degrees F (185 degrees C).
• Separate the onion slices into rings, and set aside. In a small bowl, stir together the flour, baking powder and salt.
• Dip the onion slices into the flour mixture until they are all coated; set aside. Whisk the egg and milk into the flour mixture using a fork. Dip the floured rings into the batter to coat, then place on a wire rack to drain until the batter stops dripping. The wire rack may be placed over a sheet of aluminum foil for easier clean up. Spread the bread crumbs out on a plate or shallow dish. Place rings one at a time into the crumbs, and scoop the crumbs up over the ring to coat. Give it a hard tap as you remove it from the crumbs. The coating should cling very well. Repeat with remaining rings.
• Deep fry the rings a few at a time for 2 to 3 minutes, or until golden brown. Remove to paper towels to drain. Season with seasoning salt, and serve.

LEONARD'S BARBEQUE ONION RING BATTER

Steps:

• Using a large mixing bowl, mix all ingredients until no lumps remain. Use jumbo yellow onion rings and slice about 3/4-inch thick.
• Coat the onion rings evenly in batter and deep fry at 350 degrees F in vegetable oil just until batter sticks to the rings. Remove the rings from the vegetable oil and drain well, then refrigerate the rings for 2 to 4 hours. You can keep refrigerated for 1 to 2 days loosely covered.
• When ready to serve, drop the onion rings into 350 degrees F vegetable oil until golden brown.

CRISPY ONION RINGS

Steps:

• Put the onions in a large bowl and cover with milk. Let soak for 30 minutes.
• Meanwhile, using a fine-sieve over a large bowl, sift together the flour, baking powder, 2 teaspoons salt, chili powder, and cumin, if using. Stir in the beer until a smooth batter is formed. Set aside.
• Drain the onions and transfer to a paper towel-lined baking sheet. Blot the onions with paper towels until dry.
• In a large, wide heavy-bottomed pot, pour in the oil to a depth of about 2 inches. Place over medium heat and heat to 400 degrees F. (The oil must be heated to 400 degrees F. since the temperature drops oil to about 375 degrees F. when the onions are added.)
• Working in batches, transfer about 8 to 10 of the onions to the batter and mix to coat well. Using tongs, pull several of the onions out of the batter, and let any excess batter fall back into the bowl. Carefully add to the oil and fry, flipping once, until golden brown and crispy, about 3 1/2 minutes per batch. Using the tongs, transfer to a dry paper towel-lined baking sheet to drain. Sprinkle with salt to taste. Repeat with the remaining onions. Serve immediately.

ONION RING BATTER

Steps:

• Cut onions crosswise into 1/2-inch-thick slices; separate into rings. Reserve small inner rings for another use. Toss remaining onion rings with 1 cup flour in large bowl until evenly coated. Let stand 30 min.
• Heat oil to 365ºF in large skillet. Meanwhile, combine cornstarch, onion powder, red pepper, baking powder and remaining flour. Whisk egg and club soda in large bowl until blended. Gradually stir in flour mixture.
• Shake excess flour off onion rings. Working in small batches, dip onion rings in batter, turning to evenly coat both sides of each onion ring with batter. Add to hot oil; fry 4 min. on each side or until golden brown on both sides. Drain on paper towels.

RESTAURANT STYLE ONION RINGS RECIPE

Steps:

• Heat vegetable oil in a deep-fryer or pot to 365 degrees. Onion slices should be about 1/4 inch thick. Separate the onion slices into rings and set aside.
• In a bowl, combine flour, baking powder and salt.
• Dip the onion slices in the flour mixture until completely coated and set aside.
• Whisk the eggs and milk into the flour mixture.
• Dip the floured rings into the batter to coat and place on a wire rack to let excess batter drip off.
• Pour the bread crumbs in a large bowl. Gently toss battered onions into the bread crumbs and and coat evenly.
• Deep fry a few rings at a time for 2-3 minutes, or until golden brown.
• Place finished onion rings on paper towels to drain.
• Season with seasoning salt and serve.