Decorativechocolateleaves Recipes

CHOCOLATE LEAVES

Steps:

• Gather the ingredients.
• Prepare a baking sheet by lining it with waxed paper or parchment paper..
• Place the candy coating in a microwave-safe bowl and microwave it until melted, stirring after every 30 seconds to prevent overheating.
• Dip the paintbrush in the melted candy coating and brush a thick layer of chocolate on the underside of the leaf. The underside typically has more pronounced veins, and will give you a better pattern on your leaves. Make sure that you're generous with the layer of candy coating-if it's too thin, the chocolate leaf will crack when you to remove it.
• Set the leaf, chocolate side up, on the waxed paper, and repeat with the remaining leaves. You can use different colors of candy coating to make a variety of leaves, if you'd like.
• Once all of the leaves are covered with chocolate, refrigerate the tray to set the coating, for about 20 minutes.
• When the chocolate is fully set, remove the tray from the refrigerator. Carefully peel the leaves back from the chocolate, trying not to handle the leaves too much to prevent your body heat from melting the chocolate.
• If you'd like to give your leaves a metallic shine, use luster dust to decorate them when they're finished. Dip a clean, dry paintbrush in luster dust, and brush a thin layer of dust along the edges. For a more dramatic look, brush a layer of dust over the entire leaf.

DECORATIVE CHOCOLATE LEAVES

Steps:

• Dip a small brush in the melted chocolate (keep correct spreading consistency by placing small bowl of melted chocolate over larger container of hot water).
• Thinly coat the underside of the leaves.
• Run you finger along the edge of the leaves to remove any chocolate. This will make it easier to separate the leaf from the hardened chocolate.
• Place the leaves on a tray or plate covered with wax paper, chocolate side up.
• Place in fridge for about 15 minutes or until the chocolate has set.
• Hold each leaf by the stem, give stem a little twist to loosen chocolate and very slowly and carefully peel off the chocolate.
• NOTES:.
• Don't use the chocolate if it's too hot. Allow it to cool of a bit after melting.
• If the chocolate leaf is weak along the middle because of a large vein, repaint it and rechill it.
• Spread a thicker coat of chocolate over large veins.
• Failures can be remelted.

CHOCOLATE LEAVES

Steps:

• Line large baking sheet with foil. Melt chocolate in top of double boiler over simmering water, stirring until smooth and instant-read thermometer inserted into chocolate registers 115°F. Brush chocolate over veined side (underside) of 1 leaf, coating thickly and completely. Arrange chocolate side up on prepared baking sheet. Repeat with remaining leaves and chocolate, rewarming chocolate if necessary to maintain 115°F temperature. Chill leaves until firm, about 45 minutes. Starting at stem end, carefully pull back green leaf, releasing chocolate leaf; return leaves to same baking sheet. (Can be made 2 days ahead. Cover and keep chilled.) Using small artist brush, carefully brush some leaves with gold dust, if desired.
• *Available at cake and candy supply stores, or by mail from Jane's Cakes and Chocolates at 800-262-7630.